HAGAR [Discontinued]

SBC con NXP i.MX 6SoloX Processor

Disponibile nell'intervallo di temperatura industriale

Data sheet

Contattaci per maggiori informazioni e per preventivi

Contattaci

Cpu

NXP i.MX 6SoloX Processor, Single core Cortex®-A9 @ 1GHz + Cortex®-M4 core @ 227MHz

Grafica

Integrated Graphics Vivante GC400T, 2D and 3D HW accelerator

Connettività

up to 2x Fast Eth; optional WiFi + BT LE

Memoria

32-bit DDR3L memory soldered on-board, up to 1GB

Dettagli Prodotto

Informazioni tecniche

Descrizione	SBC con NXP i.MX 6SoloX Processor
Cpu	NXP i.MX6SX SoloX Processor, Single core Cortex®-A9 @ 1GHz + Cortex®-M4 core @ 227MHz
Numero Max Core	1 + 1
Memoria	Soldered on-board DDR3L memory, 32-bit interface, up to 1GB
Grafica	Integrated Graphics Vivante GC400T, 2D and 3D HW accelerator OpenGL ES 2.0, OpenGL ES 1.1, OpenVG 1.1 supported
Interfacce video	Single Channel 18-/24- bit LVDS connector + Touch Screen (I2C signals) 24-bit Parallel RGB Connector
Risoluzione video	LVDS: up to 1366x768 @60Hz, 24bpp RGB: up to 1920x1080p @60Hz, 24bpp
Memoria di massa	16MB NOR Quad-SPI Flash soldered onboard µSD Card slot Optional eMMC drive soldered on-board, up to 8GB
Rete	Up to 2x Fast Ethernet RJ-45 connectors Optional WiFi (802.11 b/g/n) + BT LE combo module + antenna onboard
USB	1 x USB 2.0 OTG port 3 x USB 2.0 Host ports on standard Type-A socket 1 x USB 2.0 Host port on internal pin header
Audio	I2S Audio interface on programmable pin header S / PDIF interface (In and Out) on programmable pin header
Porte seriali	1 x CAN Port reconfigurable as GPIO 2x RS-232 (Tx/RX signals only) + 1x RS-485 serial ports on expansion pin header
Altre interfacce	2 x I2C dedicated connectors (one reserved for Touch Screen) 6 analog inputs for A/D Conversion Programmable () expansion pin header connector, able to offer: • CSI interface input (PAL and NTSC formats supported) • Up to 20 GPIO • SPI interface • SPDIF Audio interface • I2S Audio interface • CAN interface (TTL level) • 5 x PWM • 3 x I2C • 3 x serial ports (2x RS-232 +1xRS-485 interface) Embedded Low Power RTC () Please note that some of these interfaces are factory options, other configurations are made via SW using the pin multiplexing possibilities of the i.MX6SX processor. Optional 9-Axis Motion Sensors (Accelerometer, Magnetometer and Digital Gyroscope)
Dispositivo di alimentazione	+12VDC nominal voltage +3VDC cabled Coin Cell Battery
Sistema operativo	Linux Yocto
Temperatura operativa	0°C ÷ +60 °C (commercial temp.)* -40°C ÷ +85°C (industrial version) *Measured at any point of SECO standard heastpreader for this product, during any and all times (including start-up). Actual temperature will widely depend on application, enclosure and/or environment. Upon customer to consider application-specific cooling solutions for the final system to keep the heatspreader temperature in the range indicated.
Dimensioni	89.5 x 87 mm (3.52” x 3.43”)