Главная
HAGAR

Пропустить и перейти к галереям изображений

Перейти к началу галереи изображений

HAGAR

SBC with NXP i.MX 6SoloX Processor

Available in Industrial Temperature Range

Спецификация

Свяжитесь с нами для получения более подробной информации и ценовых предложений

Связаться с нами

Центральные процессоры

NXP i.MX 6SoloX Processor, Single core Cortex®-A9 @ 1GHz + Cortex®-M4 core @ 227MHz

Графика

Integrated Graphics Vivante GC400T, 2D and 3D HW accelerator

Связность

up to 2x Fast Eth; optional WiFi + BT LE

Память

32-bit DDR3L memory soldered on-board, up to 1GB

Информация о продукте

Техническая информация

Описание	HAGAR is a new-generation all-in-one low-cost SBC designed by SECO, equipped with a NXP i.MX 6SoloX applications processor able to run Linux. HAGAR is a revolutionary product in terms of connectivity, interactivity with the real world and cost: a new concept of single board computer ready for Internet of Things applications and for the Post-PC era.
Центрального процессора	NXP i.MX6SX SoloX Processor, Single core Cortex®-A9 @ 1GHz + Cortex®-M4 core @ 227MHz
Число ядер	1 + 1
Память	Soldered on-board DDR3L memory, 32-bit interface, up to 1GB
Rрафики	Integrated Graphics Vivante GC400T, 2D and 3D HW accelerator OpenGL ES 2.0, OpenGL ES 1.1, OpenVG 1.1 supported
Bидеоинтерфейсов	Single Channel 18-/24- bit LVDS connector + Touch Screen (I2C signals) 24-bit Parallel RGB Connector
Bидеоразрешения	LVDS: up to 1366x768 @60Hz, 24bpp RGB: up to 1920x1080p @60Hz, 24bpp
Hакопителя	16MB NOR Quad-SPI Flash soldered onboard µSD Card slot Optional eMMC drive soldered on-board, up to 8GB
Cети	Up to 2x Fast Ethernet RJ-45 connectors Optional WiFi (802.11 b/g/n) + BT LE combo module + antenna onboard
Usb	1 x USB 2.0 OTG port 3 x USB 2.0 Host ports on standard Type-A socket 1 x USB 2.0 Host port on internal pin header
Aудио	I2S Audio interface on programmable pin header S / PDIF interface (In and Out) on programmable pin header
Последовательные порты	1 x CAN Port reconfigurable as GPIO 2x RS-232 (Tx/RX signals only) + 1x RS-485 serial ports on expansion pin header
Другие интерфейсы	2 x I2C dedicated connectors (one reserved for Touch Screen) 6 analog inputs for A/D Conversion Programmable () expansion pin header connector, able to offer: • CSI interface input (PAL and NTSC formats supported) • Up to 20 GPIO • SPI interface • SPDIF Audio interface • I2S Audio interface • CAN interface (TTL level) • 5 x PWM • 3 x I2C • 3 x serial ports (2x RS-232 +1xRS-485 interface) Embedded Low Power RTC () Please note that some of these interfaces are factory options, other configurations are made via SW using the pin multiplexing possibilities of the i.MX6SX processor. Optional 9-Axis Motion Sensors (Accelerometer, Magnetometer and Digital Gyroscope)
Блок питания	+12VDC nominal voltage +3VDC cabled Coin Cell Battery
Операционная система	Linux Yocto
Pабочей температуры	0°C ÷ +60 °C (commercial temp.)* -40°C ÷ +85°C (industrial version) *Measured at any point of SECO standard heastpreader for this product, during any and all times (including start-up). Actual temperature will widely depend on application, enclosure and/or environment. Upon customer to consider application-specific cooling solutions for the final system to keep the heatspreader temperature in the range indicated.
Размеры	89.5 x 87 mm (3.52” x 3.43”)

Программное обеспечение

Ссылка	SECO Technical Resources

документация

Data Sheet	[Datasheet] HAGAR Rel 1.8
Manual	[Manual] HAGAR Rel 1.1
Image	[Picture] HAGAR_back [Picture] HAGAR_front

Part Number

Prices hereunder are valid for SAMPLES (purchase limited to 3pcs).
If you would like to know prices for higher volumes, please contact us.

Grouped product items
PN HAGAR	Описание номера изделия SBC with NXP i.MX 6SoloX Processor	Связаться с нами

Accessories

Не нашли решение, которое искали?

Стандартный продукт не отвечает вашим потребностям? Компания SECO может вместе с вами разработать частично или полностью кастомизированное аппаратное и программное решение.

Узнать больше