DEV-KIT-SMARC

SMARC 2.0 / 2.1 / 2.1.1 Development Kit. (SMARC DEV KIT)

Data sheet

Wiki

Product details

Technical Info

Description	The Development Kit contains the following material: - CSM-B79 Carrier Board - Serial Adapter Cables - 1x SATA power cable - Main power Adapter cable - 1x certified High Speed DP cable, DP1.4 standard compliant - 1x certified High Speed HDMI® cable, HDMI® 2.0 compliant - DP-to-HDMI® adapter - 1x eDP cable Module not included. Must be purchased separately
Video Interfaces	LVDS/MIPI-DSI connector, interface shared with 2x eDP connectors Backlight control + LCD selectable voltages dedicated connector 2x DP++ connector HDMI® connector (can be used in alternative to 1xDP++) 2x CSI Camera input interfaces
Mass Storage	SATA M 7p connector with dedicated power connector, interface shared with M.2 Socket 2 2230 / 2242 / 2260 Key B SSD slot microSD Card Slot
Networking	Up to 2xDual RJ-45 Gigabit Ethernet connectors M.2 Socket1 2230 Key E Slot for WiFi Modules (interface shared with PCI-e x 4 slot) M.2 Socket2 2260 / 3042 Key B Slot for WWAN Modem Modules (interface shared with PCI-e x 4 slot), connected to on-board microSIM slot
Usb	1 x USB 3.0 type A Socket 1 x USB 2.0 type A Socket 1 x USB OTG micro-AB Socket 1 x USB 3.1 Type-C Socket
Pci	PCI-e x4 slot, interface shared with M.2 Slots
Audio	TRSS Mic In + Line Out Audio Jack Onboard I2S Audio Codec (TI TLV320AIC3204) + HD Audio Codec (Cirrus Logic CS4207) I2S Audio header
Serial Ports	2 x CAN ports 2 x RS-232/RS-422/RS-485 configurable serial ports on internal pin header 2 x Serial ports (Tx/Rx signals only, TTL level) on feature pin header
Other Interfaces	eSPI pin header + Flash Socket SPI pin header + Flash Socket I2C EEPROM Socket 4 x 7-segment LCD displays for POST codes Feature pin header with 2 x Serial ports, I2C, SM Bus, Watchdog and Power Management Signals GPIO / FuSa pin header FAN connector Optional Debug USB port on micro-B connector Boot selection switches JTAG connector Selector for SMARC 2.0 / 2.1.1 pinout compatibility
Power Supply	9-24V through dedicated Mini-Fit Jr 2x2 power connector or USB Type-C connector 6-17V through 2/3/4 Cell Smart Battery Connector RTC Coin cell battery holder
Operating Temperature	-40°C ÷ +85°C (industrial range) *All carrier board components must remain within the operating temperature at any and all times, including start-up; carrier operating temperature is independent of the module installed. Please refer to the specific module for more details. Actual temperature will widely depend on application, enclosure and/or environment. Upon customer to consider specific cooling solutions for the final system.
Dimensions	243.84 x 243.84mm (microATX)